when the glue is inconsistent, it is mainly caused by the pressure cylinder or the air pressure instability of the stored fluid.
1. the inlet pressure regulator should be set at 10 to 15 psi lower than the lowest pressure in the plant. the pressure used in the cylinder should be above the pressure in the middle of the regulator. avoid using pressure between the pressure gauge and low pressure. section.
2, the valve control pressure should be at least 60psi to ensure the stability of the glue.
3. finally, the glue time should be checked. if it is less than 15/1000 seconds, the glue will be unstable. the longer the glue is, the more stable the glue is.